Rc;d is a per-CPT intermediate, not a certifiable design value — the multi-CPT ξ/variance group of NEN 9997-1 is not ported.
Re-run on change
No result yet — Run to compute the required tip depth across the model.
Cross section A–A′
62.4 m · 2 points · RD New · EPSG:28992
· 0 logs
v1v2
Elevation [m NAP]
Open✕
› Desktop › GI Nootdorp 2024
Search GI Nootdorp 2024
Organize ▾New folder
Presentations
Templates
Videos
Desktop
Downloads
Documents
NameDate modifiedTypeSize
File name:
All supported files ⌄
OpenCancel
Staged files
Staged · 0 Ground investigation · GI Nootdorp 2024
PDF 15XLSX 10AGS 12
What kind of model should this build?
Showing only what your selection can build. It holds:
30 CPTs1 borehole
GEOTECH ONLY
CPT-based geotech modelInterprets each CPT into layers, then interpolates between them.
A
WITH GEOPHYSICS
Fused model with CPTsPredicts CPT profiles across the survey and adds them as soundings.
B
Create ground model
Generate your ground model
Build it in one go, or review and approve each step as it runs.
Review each stepApprove each step before the next one starts.
AutomaticWork out the materials and build the model in one go.
Building your ground model0s
Automatic · 30 soundings selected · 30 going in
Interpretative Report · v3AIRDAMShare
DRAFT · AI-ASSISTED
3. Ground model
The 3D ground model was built from 46 CPTs and 11 boreholes (Model v2, RD New, NAP). Voxels of 2 × 2 × 0.5 m were classified from qc and Rf and interpolated between soundings.
3.1 Stratigraphy
Made ground (≈1 m) overlies very soft organic clay and peat to about −5.5 m NAP, followed by firm Holocene clays with thin silt and sand interbeds. The top of the dense Pleistocene sand lies at −24.9 to −26.3 m NAP and dips gently to the south-east (Cross section A–A′).
3.2 Groundwater
A design groundwater level of −5.5 m NAP is assumed from piezometer readings.
Table 3.1 Design parameters by unit
Unit
Top m NAP
γ/γsat
qc MPa
Made ground
−3.4
17/19
4.2
Organic clay, peat
−4.5
12/12
0.3
Holocene clay
−5.5
16/16
1.0
Pleistocene sand
−25.5
19/21
18.0
Figure 3.2 Cross section A–A′ through the 3D ground model (Model v2)
4. Foundation implications
Piles founded in the dense sand achieve the 500 kN design load at tip depths of 22.5–25.0 m bgl (NEN 9997-1, Koppejan). Negative skin friction from the soft layers is included.
OB
Omar Bahgat@Adrian please check the sand-top depths against BH-03 before we issue
✓
Shared with Adrian IvorEditRobbert DriemanViewA. van der MeerView